CUSTOMFIT LUXeDynAudio Terminals

FIT LUX

Brand:JDC Electronic

Type:Electromagnetic generator for lamp

Options:Output current adjustable on request
Available without lamp
Can be used other purposes (audio terminal) on request

Developed in collaboration with the energy service of Yverdon-les-Bains. Website: www.ylb.ch

Informations and specifications

General data

FIT LUX has been imagined in order to educate the public about the value of energy. This lamp illuminates a picnic table under the trees farfrom the urban energy network.
To avoid vandalism and to successfully integrate in the mast of the lamp, the generator operates with a linear motion. It consists of a sleeve incorporating powerful ring magnets, which slides on a stainless steel tube. Inside there is a series of coils on soft iron cores.
An energy of about 20 W is created by the movement of magnets in the coils which induce an electrical current. This energy is stored in a battery via a charger. Through an electronic management system, the battery restores as lightthe energy created by the user. This light is generated by a LED with high efficiency (~ 1 W), thereby the power supplied for one minute can illuminate about 15 minutes.
FIT LUX produces 10 lx at full power. By comparison, a sodium lamp provides between 50 and 60 lx.
Like any energy system, a small part of the energy will be lost in heat. The main losses are caused by the generator, the battery (charge / discharge) and in the LED.
To reduce the shock in stops, the movable sleeve is slowed in the ends of the tube by the principle of current brake eddy made by a massive aluminum cylinder placed in the stainless steel tube.


Technical specifications

Electronic

LED

  • Maximum current
  • Maximum power
  • Current used
  • Power used
700 mA
3 W
200 mA
740 mW

PCB

  • Input Voltage
  • Output current
  • Output Voltage
  • Battery
5-24
1 A max
3.7 V (Li-Po)
Type Li-Po, 3.7 V, 1.5 Ah (adjustable)

Mechanical

Generator

  • Dimensions
  • Materials
  • Mounting
Ø30 x 1200 mm
Stainless steel, anodized aluminum
M8 x 20 mm at each end

PCB

  • Dimensions
86 x 30 mm

Floor lamp

  • Dimensions
  • Materials
  • Platen support
Ø80 x 2600 mm
Acier inox
250 x 250 x 10 mm
4 holes Ø22 mm, pitch 200 x 200 mm